MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 705)

Appendix - 63
MELSEC-Q
APPENDICES
Item A1SD75 QD75
No. of write accesses to flash ROM – Md.19
Current feed value Md.29 Md.20
Machine feed value Md.30 Md.21
Feedrate Md.31 Md.22
Valid M code Md.32 Md.25
Axis error No. Md.33 Md.23
Axis warning No. Md.34 Md.24
Axis operation status Md.35 Md.26
Current speed Md.36 Md.27
Axis feedrate Md.37 Md.28
Speed-position switching control positioning amount Md.38 Md.29
External input/output signal Md.39 Md.30
Status Md.40 Md.31
Target value Md.41 Md.32
Target speed Md.42 Md.33
OP absolute position Md.43 –
Movement amount after near-point dog ON Md.44 Md.34
Torque limit stored value Md.45 Md.35
Special start data instruction code setting value Md.46 Md.36
Special start data instruction parameter setting value Md.47 Md.37
Start positioning data No. setting value Md.48 Md.38
In speed control flag Md.49 Md.39
In speed change processing flag Md.50 Md.40
Start data pointer being executed Md.51 Md.43
Last executed positioning data No. Md.52 Md.46
Repetition counter (QD75: Md. 41 Special start repetition counter) Md.53 Md.41
Control system repetition counter – Md.42
Positioning data No. being executed Md.54 Md.44
Block No. being executed Md.55 Md.45
Positioning data being executed Md.56 Md.47
Deceleration start flag – Md.48