Generic terms and abbreviations – MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D User Manual
Page 16

A - 14
Generic Terms and Abbreviations
Unless specially noted, the following generic terms and abbreviations are used in this
manual.
Generic term/abbreviation
Details of generic term/abbreviation
PLC CPU
Generic term for PLC CPU on which QD75 can be mounted.
QD75
Generic term for positioning module QD75P1, QD75P2, QD75P4, QD75D1, QD75D2, and
QD75D4.
The module type is described to indicate a specific module.
Peripheral device
Generic term for DOS/V personal computer that can run the following "GX Developer" and "GX
Configurator-QP".
GX Configurator-QP
Abbreviation for GX Configurator-QP (SW2D5C-QD75P-E or later).
GX Developer
Abbreviation for GX Developer (SW4D5C-GPPW-E or later).
Drive unit (servo amplifier) Abbreviation for pulse input compatible drive unit (servo amplifier).
Manual pulse generator
Abbreviation for manual pulse generator (prepared by user).
DOS/V personal computer IBM PC/AT
®
and compatible DOS/V compliant personal computer.
Personal computer
Generic term for DOS/V personal computer.
Workpiece
Generic term for moving body such as workpiece and tool, and for various control targets.
Axis 1, axis 2, axis 3,
axis 4
Indicates each axis connected to QD75.
1-axis, 2-axis, 3-axis,
4-axis
Indicates the number of axes. (Example: 2-axis = Indicates two axes such as axis 1 and axis 2,
axis 2 and axis 3, and axis 3 and axis 1.)