MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 201)

5 - 113
MELSEC-Q
5 DATA USED FOR POSITIONING CONTROL
Storage buffer
memory address Setting value
Default
value
Axis 1 Axis 2 Axis 3 Axis 4
Set with a decimal.
Setting
value
Positioning data No.
1 to 600
7000 to7004
9001
9002
9003
9004
K
: Positioning data No.
: Block start designation
: Machine OPR
: Fast-OPR
: Current value changing
: Simultaneous starting of multiple axes
0 1500 1600 1700 1800
Set with a decimal.
Setting
value
K
Positioning starting point No.
The value is set to "0" by the QD75 automatically when the continuous
operation is interrupted.
1 to 50
0 1501 1601 1701 1801
Set with a decimal.
K 1
Error reset request
Setting value
After the axis error reset is completed, "0" is stored by the QD75 automatically.
(Indicates that the axis error reset is completed.)
1: Axis error is reset.
0 1502 1602 1702 1802
Set with a decimal.
K 1
Restart command
Setting value
After restart acceptance is completed, "0" is stored by the QD75 automatically.
(Indicates that the restart acceptance is completed.)
1: Restarts
0 1503 1603 1703 1803
Set with a decimal.
K 1
M code OFF request
Setting value
After the M code ON signal turns OFF, "0" is stored by the QD75 automatically.
(Indicates that the OFF request is completed.)
1: M code ON signal turns OFF
0 1504 1604 1704 1804