MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 507)

12 - 31
MELSEC-Q
12 CONTROL SUB FUNCTIONS
[7] Setting when the control unit is "degree"
Current value address
The " Md.20 Current feed value" address is a ring address between 0 and
359.99999° .
0° 0° 0°
359.99999° 359.99999°
Fig. 12.17 Current value address when the control unit is "degree".
Setting the software stroke limit
The upper limit value/lower limit value of the software stroke limit is a value
between 0 and 359.99999° .
(1) Setting when the software stroke limit is to be validated.
When the software stroke limit is to be validated, set the upper limit value in a
clockwise direction from the lower limit value.
Section A
315º
Set in a clockwise direction
Upper limit
Lower limit
90º
Section B
(a) Set the movement range of section A as follows.
• Software stroke limit lower limit value ................ 315.00000 ° .
•
Software stroke limit upper limit value................ 90.00000 ° .
(b) Set the movement range of section B as follows.
•
Software stroke limit lower limit value ................ 90.00000 ° .
• Software stroke limit upper limit value................ 315.00000 ° .
Fig. 12.18 Software stroke limit when the control unit is "degree"