MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D - Manual (Page 633)

15 - 29
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with sequence program)
Remedy
44
45 194
195 344
345 494
495
1 to 8388608
46
47 196
197 346
347 496
497
1 to 8388608
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.
48
49 198
199 348
349 498
499
QD75P :
1 to 200000 [pulse/s]
1 to 2000000000
[mm/min or another]
QD75D :
1 to 1000000 [pulse/s]
1 to 2000000000
[mm/min or another]
• With the setting brought into the setting range, turn
the PLC READY signal [Y0] from OFF to ON.
• Bring the setting into the speed limit value or below.
50 200 350 500 0, 1, 2, 3
51 201 351 501 0, 1, 2, 3
52 202 352 502 0, 1
53 203 353 503 1 to 100
54
55 204
205 354
355 504
505
1 to 8388608
56 206 356 506 0, 1
57 207 357 507 0, 1
58 208 358 508 0, 1
60
61 210
211 360
361 510
511
0 to 10000
62 212 362 512 0, 1, 2, 3
70 220 370 520 0, 1, 2, 3, 4, 5
With the setting brought into the setting range, turn the
PLC READY signal [Y0] from OFF to ON.