Melsec-q, 15 troubleshooting – MITSUBISHI ELECTRIC Mitsubishi Programmable Logic Controller QD75D User Manual
Page 621
15 - 17
MELSEC-Q
15 TROUBLESHOOTING
Related buffer memory
address
Axis 1 Axis 2 Axis 3 Axis 4
Set range
(Setting with sequence program)
Remedy
Correct the operation pattern.
(Refer to Section 5.3
Da.1
)
Same as error codes 515 to 516
Correct the control system.
(Refer to Section 5.3
Da.2
)
0
150
300
450
0, 1, 2, 3
Correct the positioning data or change the parameter
"Unit setting" of the axis to be interpolated.
(Refer to Section 9.1.6)
Same as error codes 515 to 516
• Correct the control system.
(Refer to Section 5.3
Da.2
)
• Correct the axis to be interpolated.
(Refer to Section 5.3
Da.5
)
Command speed storage
addresses of positioning
data No. 1 to 600
1 to 1000000 [pulse/s]
1 to 2000000000 [mm/min or others]
Correct the command speed.
(Refer to Section 5.3
Da.8
)
29
179
329
479
method> 0: Composite speed 1: Reference axis speed Set the "Interpolation speed designation method"
correctly.
(Refer to Section 9.1.6)