No sntp-server, Show sntp – Enterasys Networks X-Pedition XSR CLI User Manual
Page 99
SNTP Commands
XSR CLI Reference Guide 3-93
no sntp-server
This command disables the SNTP server.
Syntax
no sntp-server
Mode
Global configuration:
XSR(config)#
show sntp
This command displays the current status of the SNTP server.
Syntax
show sntp
Output
XSR>show sntp
SNTP server
Stratum
#Polls
Last Receive
30.10.1.22
10
1
00:36:39
Active
Unicast
1.1.1.1
0
0
Never…
Unicast
Client Status: Enabled
Server Status: Enabled
Poll Interval: 512
Server requests: 125
Current Time: 00:36:42-UTC-Tuesday, 30-MAR-2004
Parameter Descriptions
Clock is synchronized, stratum 10, reference is
SNTP server
30.10.1.22
The IP address of the designated SNTP server.
Stratum
Level of the network where the clock is located. The primary stratum is
generally considered at stratum 1. The XSR default stratum is 10.
#Polls
Sum of client requests to the SNTP server.
Last Receive
Hour, minute and second of the last client reply from the SNTP server.
Active
Whether the SNTP is in active state.
Unicast
SNTP server point‐to‐point mode.
Client Status
State of the SNTP client ‐ enabled or disabled.
Server Status
State of the SNTP server ‐ enabled or disabled.
Poll Interval
Interval in seconds between client requests to the SNTP server.
Server requests
Sum of client requests to the server.