Enterasys Networks X-Pedition XSR CLI - Manual (Page 147)

Hardware Controller Clear and Show Commands
XSR CLI Reference Guide 4-95
Syntax
clear interface serial [card/port]
Mode
Privileged EXEC: XSR#
Example
XSR#clear interface serial 1/0
show controllers fastethernet
This command displays detailed FastEthernet controller data for a port. This interface is available
on the XSR 1800 Series routers only.
Syntax
show controllers fastethernet number
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Sample Output
The following example displays output from FastEthernet port 1:
XSR(config)#show controllers fastethernet 1
Packet Processor Tx Scheduler Stats:
157 Packet driver Tx OK
0 Packet driver not Tx: MUX END_ERR_BLOCK
0 Packet driver not Tx: MUX ERROR
0 Packet driver not Tx: Unknown Msg from MUX
The unit number is 1.
The interrupt number is 15.
Memory: base = 0xef600800
Vars: PollCount = 2806, g_eth1Interrupt = 0, bRxRunning = 0
Vars: bTxClean = 0, outQHung = 0
[...]
TX RING ENTRIES:
The ring starts at 0x01fcd000.
TxDRNum = 256, pTxMblkDR = 0x005f4824, TxDRIdx = 0
TxDRCleanIdx = 0
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
card XSR card number.
port XSR port number.
number FastEthernet interface number, ranging from 1 to 2.