Enterasys Networks X-Pedition XSR CLI - Manual (Page 340)

PIM Commands
7-92 Configuring IP Multicast
Default
60 seconds
Example
The following example changes the PIM‐SM message interval to 120 seconds:
XSR(config-if)#ip pim message-interval 120
ip pim query-interval
This command sets the frequency of Protocol Independent Multicast (PIM) router query
messages.
Syntax
ip pim query-interval seconds
Syntax of the “no” Form
The no form of this command sets the interval to the default value:
no ip pim query-interval
Mode
Interface configuration: XSR(config-if)#
Default
30 seconds
Example
This example resets the PIM router query message interval to 60 seconds:
XSR(config-if)#ip pim query-interval 60
ip pim rp-address
This command sets the static Rendezvous Point (RP) for the specific multicast group.
(Dynamically learned RP always has a higher priority than statically configured RP.)
Syntax
ip pim rp-address rp-address [access-list]
seconds Interval to send periodic PIM router query messages. Range: 1 to 65535.
rp-address IP address of a router to be a PIM RP. This is a unicast IP address in
four‐part, dotted notation.
access-list ACL number defines for which multicast groups the RP should be used.