Enterasys Networks X-Pedition XSR CLI - Manual (Page 516)

Other ADSL Commands
13-90 Configuring ADSL
Defaults
• Backup: Disabled
• VPN: Disabled
• Description: Set to the empty string
• Encapsulation: None
• IP: Not configured
• PPP: Not configured
• OAM procedures: Disabled
• ATM PVC VPI/VCI: Set to 1/32
• The sub‐interface will be in the shutdown state
Example
The following example creates an ATM sub‐interface object on ATM interface slot 0, card 1, port 1:
XSR(config)#interface atm 0/1/1.1 point-to-point
XSR(config-if)#
backup
This command configures and enables a backup interface for this ATM sub‐interface. This
command requires a properly configured ATM sub‐interface and Dialer group.
Syntax
backup {delay down-wait {up-wait | never} | interface dialer id | time-range
begin-hh:mm end-hh:mm}
Syntax of the “no” Form
The no form of this command disables a backup for this ATM sub‐interface:
no backup {delay | interface | time-range}
Mode
ATM Sub‐Interface configuration: XSR(config-ifx/x/x.x>)#
down-wait Seconds to wait before switching to the backup interface.
up-wait |
never Seconds to wait before switching back to ATM interface. If set to never, it
will remain on the backup interface.
id Dialer to use for backup when ATM interface is down.
begin-hh:mm Time of day to switch to the backup line regardless of ATM interface state.
end-hh:mm Time of day to revert to normal interface backup procedures.