Enterasys Networks X-Pedition XSR CLI - Manual (Page 359)

PPP Commands
XSR CLI Reference Guide 8-89
Syntax of the “no” Form
The no form of this command disables either function:
no ppp chap {hostname | refuse | password}
Mode
Interface configuration: XSR(config-if<xx>)#
Examples
The following example creates the alternate CHAP hostname freud and the default chap password
sigmund:
XSR(config)#interface dialer 1
XSR(config-if)#encapsulation ppp
XSR(config-if)#ppp chap hostname freud
XSR(config-if)#ppp chap password sigmund
The following example enables CHAP authentication refusal:
XSR(config)#interface dialer 1
XSR(config-if)#encapsulation ppp
XSR(config-if)#ppp chap refuse
ppp keepalive
This command sets the keepalive timer on a Point‐to‐Point port. PPP keepalives are sent out as
echo requests over the PPP port at specified intervals. They apply to any serial port on which PPP
encapsulation is enabled. If you do not specify the interval the default interval is used.
When Link Quality Management (LQM) is enabled on the interface along with ppp keepalive, echo
requests are disabled. Upon disabling the LQM feature echo requests will start again if ppp
keepalive is still configured.
Syntax
ppp keepalive [period]
Syntax of the “no” Form
Use the no form of the command to disable the keepalives:
no ppp keepalive
Default
Enabled at 30 seconds
Mode
Interface configuration: XSR(config-if<xx>)#
period Keepalive period in seconds.