Enterasys Networks X-Pedition XSR CLI - Manual (Page 378)

Multilink PPP Commands
8-108 Configuring the Point-to-Point Protocol
Status
Multilink PPP Commands
interface multilink
This command names the multilink group and creates a logic interface for this multilink group.
Only the PPP multilink group is supported currently.
Syntax
interface multilink number [1-32767]
Syntax of the “no” Form
The no form of this command deletes the multilink group:
no interface multilink number [1-32767]
Default
No multilink group
Mode
Global configuration: XSR(config)#
Next Mode
Multilink Interface configuration: XSR(config-ifxx>)#
Example
The following example enables multilink on group 2 with serial interface 1/1 configured as the
physical interface:
XSR(config)#interface multilink 2
XSR(config-if)ppp multilink endpoint ip 192.168.10.214
XSR(config-if)ip address 192.168.10.213 255.255.255.252
XSR(config-if)no shutdown
XSR(config)#interface serial 1/1
XSR(config-if)#media-type X21
Range Integer ‐ Disabled or Enabled
Description If enabled(2), the local node will try to perform LQR negotiation with the remote
node. If disabled(1), negotiation is not tried. The local node will comply with
any magic number negotiations tried by the remote node, according to the PPP
RFC. Changing this object takes effect when the link is next restarted.
Default Enabled
1-32767 Designation of the virtual multilink group.