Enterasys Networks X-Pedition XSR CLI - Manual (Page 429)

Frame Relay Clear and Show Commands
XSR CLI Reference Guide 9-105
show frame-relay lmi
This command displays Local Management Interface (LMI) statistics. Enter the command without
arguments to obtain statistics about all Frame Relay interfaces.
Syntax
show frame-relay lmi [interface] [interface-num]
Mode
EXEC or Global configuration: XSR> or XSR(config)#
Sample Output
The following example displays output on Serial interface 2/0 from an XSR with a Serial NIM
installed:
XSR#show frame-relay lmi
LMI Statistics for Serial 2/0 (Frame Relay DTE) LMI = AUTO (AUTO)
Interface = INACTIVE
Status Enq. Sent = 0 Status Msg. Rcvd = 0
Status Timeout = 0 Updated Status Rcvd = 0
# configured PVCs = 2 Invalid L2 LMI info = 0
local sequence number = 127
net sequence number = 127
# PVCs reported by LMI = 0 Invalid L3 LMI Info = 0
Down DLCIs:
16, 18
The following example displays output on Serial interface 2/0:1 from an XSR with a T1/E1 Serial
controller NIM installed:
LMI Statistics for Serial 0/2/0:1 (Frame Relay DTE) LMI = NONE
Interface = down
Status Enq. Sent = 0 Status Msg. Rcvd = 0
Status Timeout = 0 Updated Status Rcvd = 0
# configured PVCs = 1 Invalid L2 LMI info = 0
local sequence number = 127
net sequence number = 127
# PVCs reported by LMI = 0 Invalid L3 LMI Info = 0
in fragments with unexpected
B bit set Sum of fragments received by this DLCI that have an unexpected B (Begin) bit set.
When this occurs, all fragments being reassembled are dropped and a new frame is
begun with this fragment.
out interleaved packets Sum of packets leaving this DLCI that have been interleaved between segments.
interface
-num The interface or sub‐interface number of the Frame Relayport or sub‐interface
affec ted by this command. If interface serial interface‐num is not specified, then
this command applies to all Frame Relay ports. If interface‐num specifies a sub‐
interface, then only DLCIs in that particular sub‐interface may be cleared. If
interface‐num calls for a port, then all DLCIs on the Frame Relay interface will be
cleared.