Enterasys Networks X-Pedition XSR CLI - Manual (Page 471)

ISDN Debug and Show Commands
Book Title goes here 11-93
Syntax of the “no” Form
The no form of this command removes ISDN message tracing. You may choose to issue the
command with all or no parameters selected.
no debug isdn slot/card/port Q931 | Q921 [limit {10‐9999}]
Default
Messages: 100
Mode
EXEC Configuration: XSR
Examples
The following example configures Layer 3 ISDN debugging on the specified interface:
XSR#debug isdn 0/1/0 q931
ISDN-DBG 0/1/0 Enable Q931 Tracing
show controllers bri
This command displays physical line data concerning Basic Rate Interface (BRI) sub‐interfaces.
Syntax
show controllers bri [board/slot/port] [:channel number]
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Example
The following output is produced for BRI sub‐interface 2/1:0
XSR#show controllers bri 2/1:0
Forward Engine Serial Layer Tx/Rx Stats:
RX FROM UPPER LAYER & TX TO DRIVER
Pcks Rx = 0
Pcks Tx = 0
Pcks Discarded = 0
RX FROM DRIVER & TX TO UPPER LAYER
Pcks Rx = 0
Pcks Tx = 0
Pcks Discarded = 0
board XSR board, slot and port numbers: <1-2>/<0-1>
/slot Card, port and D‐channel or, <1-2>/<0-1>:<0-2>
/port Card, port and channel (0 = D, 1 = B1, 2 = B2).