Enterasys Networks X-Pedition XSR CLI - Manual (Page 42)

snmp-server Commands
1-28 Network Management
snmp-server tftp-server-list
This command specifies an Access Control List (ACL) to limit TFTP servers’ access during SNMP
downloads.
Syntax
snmp-server tftp-server-list access-list-num
Syntax of the “no” Form
The no form removes any ACL limiting other TFTP servers’ access during SNMP downloads:
no snmp-server tftp-server-list
Mode
Global configuration: XSR(config)#
Example
The following example limits TFTP servers to ACL #57:
XSR#snmp-server tftp-server-list 57
snmp-server trap-source
This command sets the interface serving as the source for all traps and informs. Use the address of
the interface from which the trap/inform goes out as the source address for the trap/inform.
Syntax
snmp-server trap-source {interface}
Syntax of the “no” Form
The no form of this command removes the configured trap interface:
no snmp-server trap-source
Example
This example specifies GigabitEthernet interface 2 as the trap source:
XSR#snmp-server trap-source g2
access-list-num Standard ACL ranging from 1 to 99.
interface A supported interface such as FastEthernet 1.
Note: If the interface does not have an IP address or if the interface is deleted afterwards, it will use
the address of the interface from which the trap/inform goes out as the source address for the trap/
inform.