Enterasys Networks X-Pedition XSR CLI - Manual (Page 330)

BGP Debug Commands
6-134 Configuring the Border Gateway Protocol
Display Parameters
show ip traffic
This command display BGP statistics among other IP data.
Syntax
show ip traffic
Mode
EXEC configuration: XSR>
Example
The following sample outputdisplays only BGP‐specific data:
XSR#show ip traffic
BGP Statistics:
Rcvd: 184 total
3 opens, 0 notifications, 4 updates
177 keepalives, 0 route-refresh
Sent: 186 total
4 opens, 0 notifications, 6 updates
176 keepalives, 0 route-refresh
BGP Debug event generated by the BGP process.
Rx Update Update message has been received.
Tx Update Update message being transmitted.
Nbr Neighbor IP address.
w/ attr Path Attributes in the update message.
Origin Origin of the path.
AS_SEQ Path AS Sequence Path list.
Next Hop Next Hop IP address.
Med Multi‐exit discriminator.
Rx NLRI Received Network Layer reachability information.
Prefix Network IP address.
Len Length of prefix mask.
Tx NLRI Transmitted Network Layer reachability information.