Enterasys Networks X-Pedition XSR CLI - Manual (Page 510)

CMV Commands
13-84 Configuring ADSL
Syntax
cmv append command-ID offset value
Mode
ATM Interface configuration: XSR(config-ifxx>)#
Example
The following example adds the CMV DOPT 1 with a hex value:
XSR(config-if)#cmv append DOPT 1 0x306090c0
cmv clear
This command removes all Command Management Variable (CMV) commands from the CMV
training list which is used by the DSP firmware when the line is in training mode. This command
is intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the
Flash: directory.
Syntax
cmv clear
Mode
ATM Interface configuration: XSR(config-ifxx>)#
Example
The following example deletes all CMVs from the training list:
XSR(config-if)#cmv clear
cmv cr
This command reads a Command Management Variable (CMV) from the DSP. This command is
intended for use by Enterasys field service personnel only.
This command requires that the ADSL NIM be installed and the DSP firmware file be present in
the
Flash: directory.
command-ID Represents a 4‐character CMV command.
offset Decimal or hexadecimal number representing where to write the value.
value Decimal or hexadecimal number.