Enterasys Networks X-Pedition XSR CLI - Manual (Page 477)

ISDN Debug and Show Commands
Book Title goes here 11-99
show isdn service
This command displays the service status of all or selected ISDN ports.
Syntax
show isdn service [board/slot/port]
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Parameter Descriptions
Examples
The following example displays statistics fom the BRI NOAM port:
XSR#show isdn service 1/1
********************** ISDN Service ISDN-BRI 1/1 ********************
Layer 1: UP Layer 2: UP State: ONLINE Admin Up Oper Up
Term. 1 Spid:2200555 State: ONLINE Cause: 000
Term. 2 Spid:2201555 State: ONLINE Cause: 000
Ch No State Ch No State Ch No State Ch No State Ch No State
1 IDLE 2 IDLE
The following example shows output from BRI port 1/0:
#show isdn service 1/0 (BRI)
********************** ISDN Service ISDN-BRI 1/0 ********************
Layer 1: UP Layer 2: UP State: ONLINE Admin Up Oper Up
Ch No State Ch No State Ch No State Ch No State Ch No State
1 IDLE 2 IDLE
The following example shows output from PRI port 2/0:
XSR#show isdn service 2/0
********************** ISDN Service ISDN-PRI 2/0 ********************
Layer 1: UP Layer 2: UP State: ONLINE Admin Up Oper Up
Ch No State Ch No State Ch No State Ch No State Ch No State
0 CONNECTED 1 CONNECTED 2 CONNECTED 3 CONNECTED 4 CONNECTED
5 CONNECTED 6 CONNECTED 7 CONNECTED 8 CONNECTED 9 CONNECTED
10 CONNECTED 11 CONNECTED 12 CONNECTED 13 CONNECTED 14 CONNECTED
15 D-channel 16 CONNECTED 17 CONNECTED 18 CONNECTED 19 CONNECTED
board/slot/port XSR board, slot and port numbers.
Layer 1 Status ACTIVE| DEACTIVE | PENDING ‐ (Active ‐ cable up and line synchronized)
Layer 2 Status LAPD: UP | DOWN; State: OFFLINE (Offline ‐ ISDN is not registered with
SPIDs or SPIDs not required)