Enterasys Networks X-Pedition XSR CLI - Manual (Page 58)

RTR-mode Commands
1-44 Network Management
Default
Quota: 700
Example
The following example registers the RTR owner:
XSR(config)#rtr owner operator1 192.168.57.5 email [email protected] quota 1000
rtr schedule
This command schedules an Response Time Reporter (RTR) entry.
Syntax
rtr schedule operation-id [[life {forever | lifetime}] start-time
{hh:mm:[ss][month day | day month] | pending | now | after hh:mm:ss}]
Mode
Global configuration: XSR(config)#
Default
pending
Example
The following example schedules the RTR measurement immediately:
XSR(config)#rtr schedule 1 now
operation-id Measurement ID number, ranging from 1 to 2,147,483,647.
lifetime Entry lifespan, ranging from 1 to 2,147,483,647 seconds.
hh:mm:ss Time in hours, minutes and seconds.
day Day of the month.
month Month of the year.
pending Operation will not begin. This state is meaningful when used by SNMP.
After an entry is scheduled, all supported metrics meaningful to the
protocol type will be measured.