Enterasys Networks X-Pedition XSR CLI - Manual (Page 518)

Other ADSL Commands
13-92 Configuring ADSL
XSR(config-if)#crypto ezipsec
XSR(config-if)#crypto ipsec df-bit copy
XSR(config-if)#crypto map ets-vpn
description
This command adds a description string to an existing ATM sub‐interface. This command
requires a properly configured ATM sub‐interface.
Syntax
description description_text
Syntax of the “no” Form
The no form of this command sets the description text to an empty string:
no description
Mode
ATM Sub‐Interface configuration: XSR(config-ifxx.x>)#
Example
The following example adds the ADSL VC 1/32 text string to the sub‐interface object:
XSR(config-if)#description “ADSL VC 1/32”
encapsulation
This command selects the data encapsulation method for this ATM sub‐interface. Be aware that an
encapsulation method must be selected before the sub‐interface can pass data.
Syntax
encapsulation {mux | snap}{ipoa | pppoa | pppoe} [service-name]
description
_text A string describing the sub‐interface object. Text with embedded spaces must
be enclosed in double quotes. Omitting text causes an empty string.
Note: This command requires a properly configured ATM sub-interface. In order to change
encapsulation, you must issue the no encapsulation command first before restting the value.
mux VC multiplexing (per RFC‐2684/1483).
snap LLC/SNAP multiplexing (per RFC‐2684/1483).
ipoa IP encapsulated traffic flows on this VC (per RFC‐2684).
pppoa PPP encapsulated traffic flows on this VC (per RFC‐2364).
pppoe PPP over Ethernet encapsulated traffic flows on this VC (per RFC‐2516).