Enterasys Networks X-Pedition XSR CLI - Manual (Page 197)

OSPF Debug and Show Commands
XSR CLI Reference Guide 5-121
Sample Output
The following are sample responses:
XSR#show ip ospf neighbor
ID
Pri State Dead Intvl Address Address
10.7.7.1 1 FULL 40 10.5.6.1 FastEthernet6
10.0.0.1 1 FULL 40 10.1.1.1 FastEthernet3
XSR#show ip ospf neighbor detail
Neighbor 10.7.7.1 interface address 10.5.6.1
In the area 0.0.0.0 via FastEthernet6
Neighbor priority is 1, state is FULL.
Options 1
Dead interval is 40 sec(s)
Link state retransmission interval is 5 sec(s)
Neighbor 10.0.0.1, interface address 10.1.1.1
In the area 0.0.0.0 via FastEthernet3
Neighbor priority is 1, State is FULL
Options 1
Dead interval is 40 sec(s)
Link state retransmission interval is 5 sec(s)
Parameter Description
show ip ospf virtual-links
This command displays data about virtual links configured on a router.
Syntax
show ip ospf virtual-links
Mode
EXEC or Global configuration: XSR> or XSR(config)#
ID Router ID of the neighbor.
Pri Priority of the neighbor over this interface.
State OSPF communication state with followed by the interface status of the neighbor.
Dead Intvl Interval this router will wait without receiving a Hello packet from a neighbor
before declaring a neighbor as being down.
Address IP address of the neighbor over the interface (see next field).
Interface Interface of this router over which it has neighbors identified by the neighbor ID.
In the area Area over which this router is a neighbor.
Options Decimal equivalent of the E‐bit from the options field. 0 indicates the area is a stub
area, 2 indicates the area is capable of accepting external LSAs (not a stub).