Enterasys Networks X-Pedition XSR CLI - Manual (Page 260)

Network Address Translation Commands
5-184 Configuring the Internet Protocol
Next Mode
IP Local Pool configuration: XSR(ip-local-pool)#
Example
The following example creates local IP address pool marketing, which contains all IP addresses in
the range 203.57.99.0 to 203.57.99.255:
XSR(config)#ip local pool marketing 203.57.99.0 255.255.255.0
exclude
This sub‐command bars the use of a range of IP addresses from an earlier created IP pool.
Syntax
exclude {ip address}{number}
Syntax of the “no” Form
The no form of this command removes the specified IP address from the exclude list:
exclude {ip address}{number}
Mode
Local IP Pool configuration: XSR(ip-local-pool)#
Examples
The following example excludes the ten IP addresses between 192.168.57.100 and 192.168.57.110
from local pool HQ:
XSR(config)#ip local pool HQ 192.168.57.0 255.255.255.0
XSR(ip-local-pool)#exclude 192.168.57.100 10
The following example negates the exclusion of IP addresses 192.168.57.105 and 192.168.57.106
from the earlier excluded range of IP addresses in local pool HQ:
XSR(config)#ip local pool HQ
XSR(ip-local-pool)#no exclude 192.168.57.105 2
ip nat pool
This command defines a pool of IP addresses for Network Address Translation (NAT). NAT pools
are configured using the
ip local pool command and then registered as being used by NAT. A
pool must be registered by the XSR or it will not be attached to an interface.
ip address Starting address to be excluded from pool.
number Number of addresses to exclude ranging from 1 to 65535.