Enterasys Networks X-Pedition XSR CLI - Manual (Page 476)

ISDN Debug and Show Commands
11-98 ISDN BRI and PRI Commands
show isdn active
This command displays current call information of all BRI or PRI ports, or only the selected port
specified by board/slot/port identifier.
Syntax
show isdn active [board/slot/port]
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Sample Output
The following output displays current call data on BRI interface 1/0:
XSR#show isdn active 1/0
************************** ISDN Stats ISDN-BRI 1/0 **********************
Layer 1: UP Layer 2: UP State: ONLINE Admin Up Oper Up
Ch No State Dir Speed Called / Start Calling / Destination Cause
1 CONNECTED OUTGOING 64 2100 0
07:27:52:314 Outgoing Test Call
2 CONNECTED INCOMING 64 2100 2100 0
07:27:52:686 Unknown Call
Parameter Descriptions
board/slot/port XSR board, slot and port numbers.
Call Type Type of call: INCOMING for incoming, OUTGOING for outgoing or ‐‐
when call direction cannot be determined.
Calling or Called Phone Number for outgoing call displays.
10 least significant digits
of called number 8 least significant digits of called sub‐address.
The following parameters are for incoming call displays:
10 least significant digits
of calling number 8 least significant digits of the calling sub‐address. If the incoming
SETUP message does carries the relevant information element, nothing
will be printed.
Destination Specifies the Dialer interface/Dialer session that handles the call. The
name display is limited to 10 characters.
Speed 56 or 64.
B/S/P Port ID Board/Slot/Port.
Cause 3‐digit number from 0 to 127 sent by the CO in a Cause Information
Element. Refer to the table in the Configuring ISDN chapter of the XSR
User’s Guide for Cause Code explanations.
Start Call start date and time.
End Call end time.