Enterasys Networks X-Pedition XSR CLI - Manual (Page 438)

Dialer Interface Commands
10-84 Configuring the Dialer Interface
• The dialer string command must be set to the dialer interface that owns the dialer pool
where the dialer DTR serial interface is added.
• The serial interface must be configured for synchronous data mode.
• The modem must be configured with DTR‐controlled dialing interface, CTS follows DCD,
DTR disconnects, sync data mode and a preset dialing out telephone number.
Syntax
dialer dtr
Syntax of the “no” Form
no dialer dtr
Default
DTR dialing is disabled
Mode
Interface configuration: XSR(config-if<xx>)#
Example
XSR(config-if)#dialer dtr
dialer pool
This command specifies which dialer pool the dialer interface should use. The dialer interface will
use one of the physical interfaces in the dialer pool to attach to the interfaceʹs configured
destination.
Syntax
dialer pool number
Syntax of the “no” Form
no dialer pool
Default
Disabled ‐ no pool is specified.
number Dial pool number, ranging from 1 to 255.