Enterasys Networks X-Pedition XSR CLI - Manual (Page 449)

Dial Backup Commands
XSR CLI Reference Guide 10-95
XSR(config)#interface fastethernet 2
XSR(config-if)#no shutdown
XSR(config)#interface fastethernet 2.1
XSR(config-if>)#backup interface dialer 57
XSR(config-if>)#encapsulation ppp
XSR(config-if>)#ip address negotiated
XSR(config-if>)#ip mtu 1492
XSR(config-if>)#no shutdown
backup time-range
This command configures a period when the backup dialer should be up and down, regardless of
traffic on the line. A backup dialer port is configured to protect a primary interface and once its
time‐range is specified, the backup dialer port can be enabled and disabled.
Syntax
backup time-range start-time end-time
Syntax of the “no” Form
The no form of this command disables the time‐range feature:
no backup time-range
Default
None
Mode
Interface configuration: XSR(config-if<xx>)#
Examples
The example below configures Dialer port 1 to be enabled at 6:30 a.m. and to disable itself at 11:55
p.m.
XSR(config)#interface serial 1/1
XSR(config-if)#backup interface dialer 1
XSR(config-if)#no shutdown
XSR(config-if)#backup time-range 06:30 23:55
start-time Time in hh:mm when the dialer port should be enabled.
end-time Time in hh:mm when the dialer port should be disabled.