Ip local pool – Enterasys Networks X-Pedition XSR CLI User Manual
Page 606
DHCP Commands
15-96 Configuring DHCP
ip local pool
This command, when issued multiply, configures a local pool of IP addresses to be used for a
DHCP Server pool range. Use it in conjunction with the no form of to create one or more local
address pools from which IP addresses are assigned when a remote peer connects.
The command acquires IP Local Pool mode and makes available the following sub‐commands:
•
exclude
‐ Bars a range of IP addresses from the local pool. Refer to
for the sub‐
command definition.
•
exit
‐ Quits IP Local Pool configuration mode. Refer to
definition.
Syntax
ip local pool pool-name subnet-address subnet-mask
Syntax of the “no” Form
Use the no form of this command to delete an IP address from the pool:
no ip local pool pool-name
Default
No address pools are configured
Mode
Global configuration:
XSR(config)#
Next Mode
IP Local Pool configuration:
XSR(ip-local-pool)#
Examples
The following example creates a local IP address pool named marketing, which contains all IP
addresses in the range 203.57.99.0 to 203.57.99.255:
XSR(config)#ip local pool marketing 203.57.99.0 255.255.255.0
Note: For clients that use a statically defined IP address (do not use DHCP to obtain an IP address),
you must exclude that address from the local pool.
pool-name
Name of a particular local address pool.
subnet-address
Base address of an IP subnet used to allocate IP addresses.
subnet-mask
Subnet mask of that IP subnet. All subnet address bits matching zero bits in the
mask must also be zero; that is, subnet and mask must be zero.