Enterasys Networks X-Pedition XSR CLI - Manual (Page 222)

Policy-Based Routing Commands
5-146 Configuring the Internet Protocol
Examples
The following example enables PBR on interface FastEthernet 2:
XSR(config-if)#ip policy
The following example enables PBR on interface Dialer 57:
XSR(config-if)#ip policy
route-map pbr
This command adds or deletes PBR route‐map entries and acquires PBR Map configuration mode.
The following commands are subsets of Route Map PBR functionality:
• match ip address - Adds/deletes PBR match clauses. See page 5‐147 for command
definition.
• set ip next-hop ‐ Adds or deletes PBR set clauses for the next‐hop router. See page 5‐147 for
command defintion.
• set interface ‐ Adds or deletes PBR set clauses on an interface. See page 5‐148 for command
defintion
Syntax
route-map pbr sequence-number
Syntax of the “no” Form
The no command deletes the specified policy entry or the whole policy table if no sequence
number is specified:
no route-map pbr [sequence-number]
Mode
Global configuration: XSR(config)#
Next Mode
PBR Map configuration: XSR(config-pbr-map)#
Example
In the following example, policy entry number 10 is created:
XSR(config)#route-map pbr 10
XSR(config-pbr-map)#
sequence-number Sequential number of the policy entry in the PBR route map table.