Enterasys Networks X-Pedition XSR CLI - Manual (Page 412)

Frame Relay Commands
9-88 Configuring Frame Relay
XSR(config)#interface serial 1/0
XSR(config-if)#no shutdown
XSR(config-if)#encapsulation frame-relay
XSR(config-if)#frame-relay intf-type dte
XSR(config-if)#frame-relay lmi-type ansi
The following example configures Serial interface 1/0 to act as a Frame Relay DCE, and to use the
ANSI Annex‐D LMI:
XSR(config)#interface serial 1/0
XSR(config-if)#no shutdown
XSR(config-if)#encapsulation frame-relay
XSR(config-if)#frame-relay intf-type dce
XSR(config-if)#frame-relay lmi-type ansi
frame-relay lmi-t391dte
This command sets the interval between LMI Link Integrity Verification (LIV) message
transmissions on the Data Terminal Equipment (DTE) interface.
Syntax
frame-relay lmi-t391dte period_in_sec
Syntax of the “no” Form
Use the no command to restore the default interval value:
no frame-relay lmi-t391dte
Default
10
Mode
Interface configuration: XSR(config-if<xx>)#
Example
Refer to the example in the lmi-n391dte command on page 89 .
Note: On third-party devices, the LMI LIV period may be configured using the KeepAlive
configuration on the interface.
period_ in_sec Sets the interval between LMI LIV polls, ranging from 5 to 330 seconds.