Enterasys Networks X-Pedition XSR CLI - Manual (Page 148)

Hardware Controller Clear and Show Commands
4-96 Configuring Hardware Controllers
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
[...]
RX RING ENTRIES:
The ring starts at 0x01fcc000.
RxDRNum = 128, pRxMblkDR = 0x01f33c88, RxDRIdx = 19
RxBuffSize = 1728, RxBuffOffset = 160
dataLen 0x00000000, status 0x00008000, buffer 0x01cc6c20
dataLen 0x00000000, status 0x00008000, buffer 0x01cc72e0
dataLen 0x00000000, status 0x00008000, buffer 0x01cc79a0
dataLen 0x00000000, status 0x00008000, buffer 0x01cc8060
dataLen 0x00000000, status 0x00008000, buffer 0x01cc8720
[...]
show controllers gigabitethernet
This command displays detailed FastEthernet controller data for an interface. This command is
available on the XSR 3000 Series routers only.
Syntax
show controllers gigabitethernet [number]
Mode
Privileged EXEC or Global configuration: XSR# or XSR(config)#
Sample Output
The following example displays output from GigabitEthernet port 1:
XSR#show controllers gigabitethernet 1
Packet Processor Tx Scheduler Stats:
0 Packet driver Tx OK
0 Packet driver not Tx: MUX END_ERR_BLOCK
0 Packet driver not Tx: MUX ERROR
0 Packet driver not Tx: Unknown Msg from MUX
The unit number is 1.
The interrupt number is 63. The source is 19.
The PHY is 1
Memory: base=0xb0064000
Vars: g_eth1Interrupt=0, mClBlkSize=0, bufsize=0
TX RING:
Ring starts at 0x815b1620.
TMaxDR=512, pTCurrDR=0x00000c30, TAddidx=0
TRemidx=0
number GigabitEthernet interface, ranging from 1 to 3.