Enterasys Networks X-Pedition XSR CLI - Manual (Page 466)

ISDN Commands
11-88 ISDN BRI and PRI Commands
Example
The following example sets up a test call on channel 24 on BRI port 1/1:
XSR#isdn disconnect 1/1 24
<186>Jul 28 22:49:51 10.10.10.20 ISDN:
No Channel Available For Test Call
isdn spid1, isdn spid2 (BRI)
This command specifies the Service Profile Identification Number (SPID) which is supplied by
your ISDN service provider.
North America (NOAM) ISDN switches use Fully Initializing Terminals (FIT) service which
require the CPE to register its SPID with the Central Office (CO) before service can begin.
Syntax
isdn spid1 spid-number {max digits| ldn} {max digits}
isdn spid2 spid-number {max digits} ldn} {max digits}
Syntax of the “no” Form
The no form of this command removes the SPID number:
no isdn spid1 {max digits| ldn} {max digits}
no isdn spid2
Mode
BRI Interface configuration: XSR(config-ifx>)
Example
The following example specifies a SPID and LDN for the B1 channel:
XSR(config-if)#isdn spid1 508876123401 5088761234
isdn switch-type (BRI/PRI)
This command sets the central office switch type for the ISDN port, and triggers the creation of the
following three dedicated serial interfaces: slot/card/port:0, slot/card/port:1 and slot/card/port:2 for the
D, B1 and B2 channels, respectively. Because this command does not have a no form, you can only
replace the switch with another, not remove it. The
show interface command displays the ISDN
interface status.
spid-number Number of the service to which you have subscribed, up to 26 digits. Assigned
by the ISDN service provide, it is a 7 to 10‐digit phone number with additional
prefix and suffix digits such as 905361707001.
If a SPID is set to 0 and the no isdn autodetect command was issued
(autodetect not active), then the line is assumed to be No FIT type and will not
attempt registration with the CO.
ldn This Local Directory Number is a 7 or 10‐digit number assigned by the service
provider. It is also used for setting the calling number for outgoing calls.