Enterasys Networks X-Pedition XSR CLI - Manual (Page 439)

Dialer Interface Commands
XSR CLI Reference Guide 10-85
Mode
Interface configuration: XSR(config-if<xx>)#
Example
The following example shows dialer interface 0 assigned to dialer pool 6.
XSR(config)#interface dialer 0
XSR(config-if)#dialer pool 6
XSR(config-if)#no shutdown
dialer pool-member
This command configures physical interfaces for dial devices only.
Syntax
dialer pool-member number [priority priority]
Syntax of the “no” Form
no dialer pool-member number
Defaults
• Disabled. When enabled, no default dialing pool number is assigned
• Priority: 0
• Minimum: 0
• Maximum: 255
Mode
Interface configuration: XSR(config-if<xx>)#
Example
The following example shows a serial interface belonging to two dialer pools with priorities
configured for each pool:
XSR(config-if)#interface serial 1/0
XSR(config-if)#dialer pool-member 1 priority 10
XSR(config-if)#dialer pool-member 2 priority 20
XSR(config-if)#no shutdown
Note: This command is intended for dialer interfaces only.
number Dialpool number ranging from 1 to 255.
priority Priority of the interface within the dialing pool - ranging from 0 (lowest) to 255
(highest). Ports with the highest priority are selected first for dialing out.