Enterasys Networks X-Pedition XSR CLI - Manual (Page 597)

DHCP Commands
XSR CLI Reference Guide 15-87
debug ip dhcp server
This command enables DHCP server debugging. This command should be used for
troubleshooting purposes only.
Syntax
debug ip dhcp server {events | packets | linkages}
Syntax of the “no” Form
Use no form of this command to disable DHCP server debugging:
no debug ip DHCP server {events | packets}
Default
Disabled
Mode
Privileged EXEC: XSR#
Example
The following example enables DHCP server events debugging:
XSR#debug ip DHCP server events
default-router
This command specifies the default router list for a DHCP client. Depending on the client
configuration inheritance, the command should be used from the proper mode. If it is specified
from multiple modes, an override mechanism chooses the innermost config value, with host as
innermost, then client‐class and pool as the most general.
Syntax
default-router address [address2...address8]
Syntax of the “no” Form
Use the no form of this command to remove the default router list:
no default-router
events Reports server events, such as address assignments and database updates.
packets Decodes DHCP receptions and transmissions.
linkages Displays database linkage data such as parent-child relationships in a radix tree.
address IP address of a default router. One IP address is required.
address2
...address8 Specifies up to eight addresses in the command line listed in order of preference
(default router address has the highest priority, then router address 2, etc.).