Enterasys Networks X-Pedition XSR CLI - Manual (Page 346)

IGMP Clear and Show Commands
7-98 Configuring IP Multicast
show ip mroute
This command displays entries in the IP multicast routing table.
Syntax
show ip mroute [][source-address][summary]
Mode
EXEC configuration: XSR>
Example
The following example displays sample responses:
XSR>show ip mroute
IP Multicast Routing Table
Flags: D - Dense, S - Sparse, C - Connected, P - Pruned
F - Register flag, T - SPT-bit set
Timers: Uptime/Expires
Interface state: Interface, Next-Hop, State/Mode
(*, 224.0.255.3), 5:29:15/00:01:14, RP is 192.168.26.2, flags:
Incoming interface: FastEthernet1, RPF neighbor 10.3.35.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 5:29:15/0:01:57
(192.168.27.0/24, 224.0.255.3), 6:29:15/00:02:47, flags: TS
Incoming interface: FastEthernet1, RPF neighbor 10.3.35.1
Outgoing interface list:
FastEthernet0, Forward/Sparse, 8:29:15/0:02:47
group-address IP address of the multicast group.
source-address IP address of the multicast source.
summary A one‐line, abbreviated summary of each entry in the IP multicast
routing table.