Enterasys Networks X-Pedition XSR CLI - Manual (Page 139)

Hardware Controller Commands
XSR CLI Reference Guide 4-87
media-type
This command sets the media‐type appropriate to the cable type that the interface is connected to.
Syntax
media-type {RS232 | RS422 | RS449 | RS530A | V35 | X21}
Mode
Interface configuration: XSR(config-if<xx>)#
Default
RS232
Example
XSR(config-if)#media-type V35
nrzi-encoding
This command sets the encoding type to NRZI. It is valid and takes effect only when the interface
is running in Synchronous mode. Some computers require the encoding type to be set to NRZI.
Syntax
nrzi-encoding
Syntax of the “no” Form
The no form of this command disable NRZI encoding:
no nrzi-encoding
Mode
Interface configuration: XSR(config-ifx>)#
Default
Disabled
Example
XSR(config-if)#nrzi-encoding
Note: The XSR Serial NIM does not detect the media-type of an attached cable. You must configure
the correct interface media-type matching the attached cable for the serial interface to function
properly.