Enterasys Networks X-Pedition XSR CLI - Manual (Page 586)

Tunnel Clear and Show Commands
14-132 Configuring the VPN
Tunnel Clear and Show Commands
clear tunnel
This command terminates a non‐GRE tunnel associated with a user or tunnel ID. Tunnels will re‐
establish themselves if set to do so unless the user is disabled in its database. For example, a
cleared IPSec tunnel will re‐establish if traffic is initiated.
L2TP and PPTP tunnels will be disconnected on the server side. The client side of the tunnel will
time out after its designated timeout period.
Syntax
clear tunnel <user-ID | <tunnel-ID>
Mode
Privileged EXEC: XSR#
Example
The following example terminates tunnel 40000001:
XSR#clear tunnel 40000001
show tunnels
This command lists all tunnels currently connected to the XSR.
Syntax
show tunnels <user-ID | tunnel-ID>
Mode
Privileged EXEC: XSR#
Sample Output
The following is sample output queried by the xsrclient User‐ID:
XSR#show tunnels xsrclient
Note: This command terminates all but GRE and GRE/IPSec tunnels with an error message
displayed if you attempt to do so. To bring down a GRE tunnel, remove its interface or use the no
set active command.
user-ID Name of the VPN user.
tunnel-ID Identification number associated with this tunnel.
user-ID Name of the VPN user.
tunnel-ID Identification number associated with this tunnel.