Enterasys Networks X-Pedition XSR CLI - Manual (Page 424)

Frame Relay Map Class Commands
9-100 Configuring Frame Relay
Syntax of the “no” Form
no map-class [frame-relay | dialer] map-class-name
Mode
Global configuration: XSR(config)#
Next Mode
FR Map‐Class configuration: XSR(config-map-class)#
Example
This example defines frame relay map‐class normlink:
XSR(config)#map-class frame-relay normlink
XSR(config-map-class)#frame-relay adaptive-shaping
XSR(config-map-class)#frame-relay cir out 64000
XSR(config-map-class)#frame-relay bc out 8000
XSR(config-map-class)#frame-relay be out 8000
XSR(config-map-class)#service-policy output HighPriority
service-policy
This command sets the service‐policy profile for the class map. The service‐policy is a flexible
method to configure QoS for an interface, sub‐interface and DLCI, You can use it to create priority
queues, custom queues, WFQ or FIFO queues. Refer to
“Configuring Quality of Service” on
page 83 for more details.
Syntax
service-policy {out} service-policy-name
Syntax of the “no” Form
The no form of this command disables a service‐policy:
no service-policy output service-policy-name
Mode
Map Class configuration: XSR(config-map-class)#
dialer Sets a dialer map class. For more information, refer to “Configuring the
Dialer Interface” on page 83 .
map-class-name Name of the map class to associate with this DLCI, up to 29 characters.
out Service policy applies to outgoing traffic only.
service-policy-
name Name of the separated configured service‐policy profile to apply for
this map‐class.