Enterasys Networks X-Pedition XSR CLI - Manual (Page 365)

PPP Commands
XSR CLI Reference Guide 8-95
Syntax of the “no” Form
Use the no form of this command to disable LQM:
no ppp quality
Default
Disabled
Mode
Interface configuration: XSR(config-if<xx>)#
Example
The following example enables LQM on Serial interface 2/0:
XSR(config)#interface serial 2/0
XSR(config-if)#encapsulation ppp
XSR(config-if)#no shutdown
XSR(config-if)#ppp quality 75
ppp timeout retry
This command sets the restart timer for Configure‐Requests and Terminate‐Requests on a Point‐
to‐Point interface. The timer is the peak interval to wait for a response during PPP negotiation.
This command applies to any serial port on which PPP encapsulation is enabled.
Syntax
ppp timeout retry seconds
Syntax of the “no” Form
The no command resets the timer to the default value:
no ppp timeout retry
Default
3
Mode
Serial, Dialer, and Fast/GigabitEthernet Sub‐interface configuration: XSR(config-if<xx>)#
Example
The following example resets the restart timer of Serial interface 1:
XSR(config)#interface serial 1/0
XSR(config-if)#encapsulation ppp
seconds Restart timer interval, ranging from 1 to 255 seconds.