Enterasys Networks X-Pedition XSR CLI - Manual (Page 237)

Other IP Commands
XSR CLI Reference Guide 5-161
Mode
Interface configuration: XSR(config-if<xx>)#
Default
1500
Example
The following example sets the MTU size to 1200 for interface Serial 1/0:
XSR(config-if)#ip mtu 1200
ip proxy-arp
This command enables/disables Proxy ARP on a per interface basis, allowing the XSR to answer
ARP requests on one network for a host on another network. It is available for Fast/
GigabitEthernet interfaces only.
Syntax
ip proxy-arp
Syntax of the “no” Form
The no form of this command disables Proxy ARP:
no ip proxy-arp
Mode
Interface configuration: XSR(config-if<xx>)#
Default
Enabled
Example
The following example disables proxy arp on interface F1:
XSR(config)#interface fastethernet 1
XSR(config-if)#no ip proxy-arp
ip proxy-dns
This command enables Proxy DNS. The XSR’s implementation of this feature supports the
configuration of a forwarding proxy server which do not perform DNS resolution but pass on and
cache DNS queries and replies to other proxy or DNS servers. Use the
show running-config
command to verify current proxy DNS settings on the XSR.