Enterasys Networks X-Pedition XSR CLI - Manual (Page 522)

Other ADSL Commands
13-96 Configuring ADSL
Example
The following example sets the OAM frequency to 20 seconds:
XSR(config-if)#oam-pvc manage 20
oam retry
This command configures parameters related to OAM cell handling for ATM VC management.
This command requires a properly configured ATM sub‐interface.
Syntax
oam retry up-count down-count retry-frequency
Syntax of the “no” Form
The no form of this command returns this parameter to its default setting:
no oam retry
Mode
ATM Sub‐Interface configuration: XSR(config-ifx/x/x.x>)#
Default
• Initial down‐count value: 5
• Initial up‐count value: 3
• Initial retry‐frequency value: 10
• Default settings apply only when OAM management has been enabled with the oam-pvc
command.
Example
This example sets the up‐count to 5, the down‐count to 8, and the retry‐frequency to 2 seconds:
XSR(config-if)#oam retry 5 8 2
pvc
This command sets the sub‐interface circuit type to PVC and specifies ATM VPI/VCI values. This
command requires a properly configured ATM sub‐interface.
up-count Sum of consecutive end‐to‐end F5 OAM loopback cells responses that must
be received to change the VC connection state to up. Range: 0 to 255.
down-count Sum of consecutive end‐to‐end F5 OAM loopback cells responses that are not
received to change the VC connection state to down. Range: 0 to 255.
retry-
frequency Interval between sending end‐to‐end F5 OAM loopback cells when a change
in the up/down state of a VC is being verified. Range: 1 to 3600 seconds.