Enterasys Networks X-Pedition XSR CLI - Manual (Page 457)

Dialer Watch Commands
XSR CLI Reference Guide 10-103
Dialer Watch Commands
dialer watch-group
This command enables Dialer Watch backup on a dialer interface with up to 16 watch‐groups.
Syntax
dialer watch-group group-number
Syntax of the “no” Form
Use the no form of this command to disable this feature:
no dialer watch-group group-number
Mode
Dialer Interface configuration: XSR(config-ifx>)#
Example
The following example configures a dialer watch group:
XSR(config-if)#dialer watch-group 57
dialer watch-list
This command adds a list of IP addresses you want monitored. Use this command with the dialer
watch‐group interface configuration command. The number of the group list must match the
group number.
Syntax
dialer watch-list group-number [delay route-check initial initial-delay][delay
connect connect-delay][delay disconnect disconnect-delay][ip ip-address address-
mask]][time-range start-time end-time]
Note: The XSR sets UTC for time-range calculation.
group-number Assigned number that will point to a globally defined list of IP addresses to
watch, ranging from 1 to 255.f
Note: The XSR sets UTC for time-range calculation.
group-number Number assigned to the list, ranging from 1 to 255.
ip IP is the only routed protocol supported for Dialer Watch at this time.
ip-address IP address or address range to be applied to the list.