Enterasys Networks X-Pedition XSR CLI - Manual (Page 415)

Frame Relay Commands
XSR CLI Reference Guide 9-91
frame-relay lmi-t392dce
This command sets polling verification timer on a Data Communications Equipment (DCE)
interface. The timer marks the duration that the DCE expects to receive a Status Enquiry from a
DTE device.
Syntax
frame-relay lmi-t392dce period_in_sec
Syntax of the “no” Form
The no form of this command restores the default interval:
no frame-relay lmi-t392dce
Default
15 seconds
Example
The following example sets the DCE to wait 20 seconds for a status enquiry from the DTE before
declaring an error event:
XSR(config)#interface serial 1/0
XSR(config-if)#encapsulation frame-relay
XSR(config-if)#frame-relay intf-type dce
XSR(config-if)#frame-relay lmi-t392dce 20
frame-relay lmi-n392dce
This command sets the error threshold on a Data Communications Equipment (DCE) interface.
Syntax
frame-relay lmi-n392dce threshold
Syntax of the “no” Form
The no form of this command removes the current setting:
no frame-relay lmi-n392dce
Default
3
events Interval to wait for a Status Enquiry, ranging from 5 to 30 seconds.
threshold Error threshold, ranging from 1 to 10.