Enterasys Networks X-Pedition XSR CLI - Manual (Page 430)

Frame Relay Clear and Show Commands
9-106 Configuring Frame Relay
Parameter Descriptions
show frame-relay map
This command displays data from current frame‐relay map entries.
Syntax
show frame-relay map
Mode
EXEC or Global configuration: XSR> or XSR(config)#
Sample Output
The following example displays a multi‐point Frame Relay map:
XSR#show frame-relay map
Frame Relay Map Statistics (Serial 2/0)
Serial 2/0.1 dlci 973 (0x3CD, 0xF0D0) Remote Addr. 10.10.10.5,
gratuitous-inverse-arp, bootp, static ip
Serial 2/0.1 dlci 972 (0x3CC, 0xF0C0) Remote Addr. 10.10.10.4,
gratuitous-inverse-arp, static ip
Serial 2/0.1 dlci 971 (0x3CB, 0xF0B0) Remote Addr. 10.10.10.3,
static ip
Serial 2/0.1 dlci 970 (0x3CA, 0xF0A0) Remote Addr. un-resolved,
gratuitous-inverse-arp
Serial 2/0.1 dlci 960 (0x3C0, 0xF000) Remote Addr. un-resolved
LMI The configured or auto‐detected LMI type. If the port is set for AUTO LMI, then the XSR
shows AUTO (nn), where nn is ILMI, ANSI, or ITU if the port has successfully negotiated/
detected the LMI supported by the switch, otherwise it displays AUTO.
Status Enq. Sent Sum of LMI status enquiry messages sent.
Status Msgs Rcvd Sum of LMI status messages received.
Status Timeouts Sum of times the status message was not received within the keepalive time value.
Update Status Rcvd Sum of LMI asynchronous update status messages received.
Invalid L2 LMI info Sum of received LMI messages with invalid unnumbered information field.
Invalid L3 LMI Sum of LMI messages with invalid fields.fields
Un‐configured DLCIs List of un‐configured DLCIs are reported to be in an Active state by the Frame Relay
switch. This field is not displayed if the configured LMI type is None.
Down DLCIs List of configured DLCIs are reported to be in a Down or Inactive state by the Frame Relay
switch. This field is not displayed if the configured LMI type is None.
Interface Down marks the port as active but not communicating with the switch; Inactive marks the
port as shut down; Up marks the port as operational.
Local/net sequence
number Value of current or next to transmit/received LMI control packet.