Enterasys Networks X-Pedition XSR CLI - Manual (Page 461)

Book Title goes here 11-83
11
ISDN BRI and PRI Commands
Observing Syntax and Conventions
The CLI Syntax and conventions use the notation described in the following table.
ISDN Commands
The following set of commands allows you to configure BRI/PRI functionality on the XSR.
interface bri
This command configures a BRI interface for each physical BRI port on the BRI NIM card. When
entered, the
interface bri command must be followed by the isdn switch-type command for
BRI ISDN applications, or the leased-line bri command for BRI leased line applications. If none
of the above commands are issued BRI ports are non‐operational.
Syntax
interface bri board/slot/port
Convention Description
xyz Key word or mandatory parameters (bold)
[x] [ ] Square brackets indicate an optional parameter (italic)
[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values
{x | y | z} { | } Braces with vertical bar indicate a choice of a required value
[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates
a required choice of an optional parameter
(config-if<xx>) xx signifies the interface type and number; e.g., F1, G3, S2/1.0, M57, BRI-
1/1, PRI-2/1. F indicates a FastEthernet, and G a GigabitEthernet
interface.
Next Mode entries display the CLI prompt after a command is entered
soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with
special emphasis
board/slot/port BRI board, slot, and port numbers. For leased‐line applications: 1 for B1
and 2 for B2. Sub‐ports are added by the
leased-line [56 | 64]
command.