Enterasys Networks X-Pedition XSR CLI - Manual (Page 136)

Hardware Controller Commands
4-84 Configuring Hardware Controllers
Syntax
clock rate bps
Syntax of the “no” Form
no clock rate
Mode
Interface configuration: XSR(config-ifx>)#
Default
9600
Example
XSR(config-if)#clock rate 19200
databits
This command sets the number of data bits accepted on a serial port. The command is valid and
takes effect only when the interface is running in Async mode. In Sync mode, the clock rate is
received externally.
Syntax
databits bits
Mode
Interface configuration: XSR(config-ifx>)#
Syntax of the “no” Form
no databits
Default
8
Example
XSR(config-if)#databits 7
bps Configures the clock rate in bits per second (baud) on the line (async only). Valid
rates are: 2400, 4800, 7200, 9600, 14400, 19200, 28800, 38400, 57600, and 115200.
bits Number of databits per character on a serial port, ranging from 5 to 8.