Enterasys Networks X-Pedition XSR CLI - Manual (Page 519)

Other ADSL Commands
XSR CLI Reference Guide 13-93
Syntax of the “no” Form
The no form of this command removes any form of encapsulation, effectively disabling the sub‐
interface:
no encapsulation
Mode
ATM Sub‐Interface configuration: XSR(config-ifxx.x>)#
Default
The default encapsulation is none. An encapsulation method must be specified before the sub‐
interface can pass data. When the sub‐interface is configured for PPPoE encapsulation, the source
Ethernet MAC address will be set to the MAC address of FastEthernet interface 2.
Example
The following example configures the sub‐interface for LLC/SNAP multiplexing and PPPoA
encapsulated traffic:
XSR(config-if)#encapsulation snap pppoa
exit
This command quits the ATM Sub‐Interface mode and returns to Global mode.
Syntax
exit
Mode
ATM Sub‐Interface configuration: XSR(config-ifxx.x>)#
Example
The following example exits the sub‐interface ATM command mode from ATM interface slot 0,
card 1, port 0, sub‐interface 1:
XSR(config-if)#exit
XSR(config)#
ip address
This command specifies the IP address and subnet mask of the ATM sub‐interface or requests the
IP address and subnet mask be negotiated. This command requires a properly configured ATM
sub‐interface.
service
-name The name of the PPPoE service. If not specified, PPPoE connects to the first
advertised service name. At this time, the XSR will connect with the first
advertised service name only.