Enterasys Networks X-Pedition XSR CLI - Manual (Page 168)

OSPF Commands
5-92 Configuring the Internet Protocol
Syntax
distance ospf {intra | inter | ext} weight
Syntax of the “no” Form
The no command resets the administrative distance to the default value for the particular type of
routes. If no type of routes is referenced, the distance for all three types of OSPF routes are reset to
the default.
no distance OSPF {intra | inter | ext}
Mode
Router configuration: XSR(config-router)#
Default
• Distances between 241 and 255 are reserved for internal use.
• The condition of intra‐area distance is less than inter‐area distance is less than external distance
is always preserved. If you attempt to configure otherwise, the configuration will fail and you
will receive a warning message.
• Default distances must not be the same for any two routing protocols.
• For default distances, refer to Table 5‐2 below.
intra OSPF intra‐area routes.
inter OSPF inter‐area routes.
ext OSPF external routes.
weight Administrative distance used by the routing protocol. Range: 1 to 240.
Table 5-1 Default Administrative Distances
Route Source Default Distance
Connected 0
Static 1
BGP external 20
OSPF intra 108
OSPF inter 110
OSPF ext 112
RIP 120
BGP internal 200
Reserved 241‐255