Enterasys Networks X-Pedition XSR CLI - Manual (Page 22)

General Network Management Commands
1-8 Network Management
Mode
Global configuration: XSR(config)#
Default
Enabled
Examples
XSR(config)#ip telnet server enable
XSR(config)#no ip telnet server
ping
This network connectivity command, which applies to IP ping only, sends five echo requests with
a configurable packet size and source IP address. Ping stops when responses are received or after
five requests are sent.
Syntax
ping dest_addr [source_addr][size pkt_size]
Mode
Privileged EXEC: XSR#
Default
Packet size: 72 bytes
Sample Output
This example shows a timed out ping with an unreachable destination:
XSR#ping 134.141.235.1
Type escape sequence to abort
Timeout
Timeout
Timeout
Timeout
Timeout
Packets: Sent = 5, Received = 0, Lost = 5
The following example shows a successful ping:
XSR#ping 134.141.235.165
Type escape sequence to abort
Reply from 192.168.27.165: 20ms
dest_addr Destination address to be pinged.
source_addr Source address for the ping packet. If not configured, the Router ID is used.
pkt_size Payload size, ranging from 1 to 65000.