Enterasys Networks X-Pedition XSR CLI - Manual (Page 472)

ISDN Debug and Show Commands
11-94 ISDN BRI and PRI Commands
Packet Processor Tx Scheduler Stats:
0 Packet driver Tx OK
0 Packet driver not Tx: MUX END_ERR_BLOCK
0 Packet driver not Tx: MUX ERROR
0 Packet driver not Tx: Unknown Msg from MUX
The unit number is 167772177.
The interrupt number is 27.
General: SCC 4 parm ram = 0xa0290f00, reg = 0xa0291660
TX RING ENTRIES:
The data ring starts at 0xa0290200.
TxDRNum = 16, pTxMblkDR = 0x010fc120, TxDRIdx = 0
TxDRCleanIdx = 0
(-2) CmdStsLen 0x00000000, pBuf 0x00000000
(-1) CmdStsLen 0x00000000, pBuf 0x00000000
( 0) CmdStsLen 0x00000000, pBuf 0x00000000
( 1) CmdStsLen 0x00000000, pBuf 0x00000000
( 2) CmdStsLen 0x00000000, pBuf 0x00000000
[...]
RX RING ENTRIES:
The data ring starts at 0xa02901c0.
RxDRNum = 8, pRxMblkDR = 0x00ffd200, RxDRIdx = 0
RxBuffSize = 1728, RxBuffOffset = 160
(-2) CmdStsLen 0x80000000, pBuf 0x21e146e0
(-1) CmdStsLen 0xa0000000, pBuf 0x21e14da0
( 0) CmdStsLen 0x80000000, pBuf 0x21e11e60
( 1) CmdStsLen 0x80000000, pBuf 0x21e12520
( 2) CmdStsLen 0x80000000, pBuf 0x21e12be0
[...]
show interface bri
This command displays the status of the B and D‐channelsʹ serial driver. Generally speaking, BRI
channels are displayed exactly as standard serial ports and PRI channels are displayed as
standard T1/E1/ISDN‐PRI serial channels.
If the B‐channel is not connected by an active call, the OPER state will be down. The D‐channel
will display L1 and L2 status in addition to standard output.
To display the D‐ or B‐channels use the following commands:
• BRI ‐ show interface bri 1/0 or show interface bri 1/0:0 ‐ for D channel
• PRI ‐ show interface serial 2/1:23 for T1 D channel
• PRI ‐ show interface serial 2/1:15 for E1 D channel
• PRI ‐ show interface serial 2/1:0 - 22 for T1 B channels