Enterasys Networks X-Pedition XSR CLI - Manual (Page 231)

Other IP Commands
XSR CLI Reference Guide 5-155
ip domain
This command identifies the domain to which the XSR belongs. If the command is reissued, it is
considered an update of the domain name and will overwrite the old value with a new value.
The XSR uses the domain name to help create a certificate subject name, which is automatically
formated to: .. You can configure the host name with the
hostname
command. If the host name is not set when you issue the ip domain command, the XSR will use
the hardcoded DefaultName.
Syntax
ip domain name {domain-name}
Syntax of the “no” Form
The no form of this command resets the IP domain name to no value:
no ip domain name {domain-name}
Mode
Global configuration: XSR(config>#
Example
In the following example, the domain name enterasys.com is used:
XSR(config>#ip domain enterasys.com
ip equal-cost multi-path
This command enables equal‐cost multi‐path routing and sets the method for path selection.
Syntax
: for enabling and setting: the selection method:
ip equal-cost multi-path {round-robin | per-flow}
Note: For Verisign CA interoperability, you must enter the domain name that you specified when
registering with Verisign.
domain-name Name of the IP domain to which the XSR belongs. Up to 128 printable
characters are permitted with no spaces.