Set active – Enterasys Networks X-Pedition XSR CLI User Manual
Page 582
Tunnel Commands
14-128 Configuring the VPN
•
set protocol -
Defines the VPN tunneling protocol used when the tunnel is created: client
mode or network extension mode. Refer to
•
set user -
Username employed when connecting to the remote peer. Refer to
for the command definition.
Syntax
tunnel tunnel-name
Syntax of the “no” Form
The no form of this command deletes the tunnel:
no tunnel tunnel-name
Mode
Interface Internet Protocol configuration:
XSR(config-int-vpn)#
Next Mode
Tunnel configuration:
XSR#(config-tms-tunnel)#
Example
The following example adds the tunnel ACME_VPN:
XSR(config)#interface vpn 57 multi-point
XSR(config-int
XSR#(config-tms-tunnel)#
set active
This command enables the tunnel.
Syntax
set active
Syntax of the “no” Form
The no form of this command disables the tunnel:
no set active
Default
Enabled
tunnel-name
The name assigned to the tunnel.